How to troubleshoot a KREMER KR-4200HW Washer that won't start?
If your KREMER Washer doesn't start when you turn on the main switch, the problem could be due to the plug not being properly connected or burnt-out connection panel fuses. Carefully check the plug and the electric cable, and replace the fuses if necessary.
What to do if my KREMER KR-4200HW has pressure leakage?
If your KREMER Washer is experiencing pressure leakage, it could be due to several reasons: a worn-out nozzle, broken or worn-out suction and/or delivery valves, foreign matter in the valves, a worn-out setting valve area, or worn-out seals. Try these solutions: * Replace the nozzle. * Check and replace the valves. * Check and clean the valves. * Check and replace the setting valve area. * Replace the seals.
Why is my KREMER Washer so noisy?
If your KREMER Washer is making excessive noise, it could be due to several factors: air suction, broken suction and/or delivery valve springs, foreign matter in the suction and delivery valves, worn-out bearings or extreme liquid temperature. Try these solutions: * Check the suction pipes. * Replace the valve springs. * Check and clean the suction and delivery valves. * Replace the bearings. * Reduce the liquid temperature.
Why does the pressure fluctuate when I turn on the lance on my KREMER KR-4200HW Washer?
If you notice pressure fluctuations when you turn on the lance of your KREMER Washer, the nozzle might be clogged or deformed, or the boiler coil or lance could be clogged with limestone. Clean or replace the nozzle and try descaling the unit.
Why isn't the water hot enough in my KREMER KR-4200HW Washer?
If the water in your KREMER Washer isn't getting hot enough, it could be due to poor boiler performance or a boiler coil clogged with limestone. Try cleaning the burner nozzle filter, cleaning the fuel filter, checking the diesel pump pressure, and descaling the unit.
Why does the motor of my KREMER Washer stop suddenly?
If the motor of your KREMER Washer stops suddenly or after a while, it might be due to the motor-protecting switch being activated because of insufficient mains voltage. Check the value of the mains voltage.
What causes irregular pressure fluctuations in my KREMER KR-4200HW?
Irregular pressure fluctuations in your KREMER Washer can be caused by worn-out suction and/or delivery valves, foreign matter in the valves, air suction, or worn-out seals. Try these steps: * Check and replace the valves. * Check and clean the valves. * Check the suction pipe. * Check and replace the seals.
Why is there too much vibration at the delivery of my KREMER KR-4200HW Washer?
Excessive vibrations at the delivery of your KREMER Washer could be due to a run-down pressure tank or worn-out or dirty valves. Check the pressure in the tank, and check or replace the valves.
Why is there too much smoke coming from the chimney of my KREMER Washer?
If your KREMER Washer is producing too much smoke from the chimney, it could be due to incorrect combustion or impurities/water in the fuel. Clean the fuel filter, clean the boiler, and empty and carefully clean the tank, also clean fuel filter.
What causes water filtrations from the drains between the casing and head of my KREMER KR-4200HW Washer?
Water filtrations from the drains between the casing and head of your KREMER Washer could be due to worn-out seals, a worn-out piston, or a worn-out O-ring of the piston cap. Replace the seals, replace the piston, and replace the seal.
To Next Page
General