Why does my KRESS KG367E fail to operate?
Your KRESS Chainsaw might not be operating because of a low battery charge. To resolve this, charge both battery packs. Another possible reason is that the chain brake is not in the correct position. Check the chain brake's position.
What to do if my KRESS KG367E Chainsaw chain/chain bar over-heats?
If your KRESS Chainsaw's chain or chain bar is overheating, it could be due to several reasons. First, check if there is oil in the reservoir and refill if necessary. A clogged vent in the oil filler cap or a clogged oil passage can also cause overheating; clean the cap and oil passage outlet to resolve this. Additionally, ensure the chain isn't over-tensioned and adjust it if needed. Finally, a dull chain can cause overheating, so sharpen or replace the chain.
What to do if my KRESS Chainsaw operates intermittently?
If your KRESS Chainsaw is operating intermittently, overheating could be the reason. Place the machine in a cool, ventilated place to cool it down. It may also happen if you are applying too much pressure while cutting, so apply relatively less pressure. If the problem persists, it might be due to a loose connection, defective internal wiring, or a defective On/Off switch. In these cases, contact a service agent.
What to do if KRESS KG367E rips, vibrates, and doesn't saw properly?
If your KRESS Chainsaw is ripping, vibrating, or not sawing properly, it could be due to a chain tension that is too loose. Adjust the chain tension accordingly. Another reason might be a dull or worn-out chain; sharpen or replace the chain as needed. Also, ensure that the chain teeth are facing in the correct direction; if not, reassemble the chain in the correct direction.
Why is the chain dry on my KRESS Chainsaw?
A dry chain on your KRESS Chainsaw can be caused by a few issues. First, check if there is oil in the reservoir and refill it if needed. Another possible cause is a clogged vent in the oil filler cap; clean the cap to resolve this. Finally, the oil passage might be clogged, so clean the oil passage outlet.
General| Motor | Brushless |
|---|---|
| Bar Length | 35 cm |
| Chain Pitch | 3/8" |
| Oil Tank Capacity | 200 ml |
| Motor Power | 1.5 kW |
To Next Page
