Krill ULTIMATE 300KS Mk2 39% - Technical Data; General Informations

2
5.4.2 Tail wheel ...................................................................................................14
5.5 Cowling.....................................................................................................................15
1. Technical data:
Wingspan
2
330
mm
Length
2
55
0 mm
Weight (RTF)
15
kg
Wing area
1
60
dm2
Wing loading
93
,7
5
g/dm2
Engine (Gas)
100
-
130
ccm
Minimum RC channels
6
Notice: This Assembly guide only shows how the model could be assembled. According to
model specification we expect, that this airplane is assembled by experienced user, which will
use his habbits and skills to finish it.
As an accesories (levers, rods, fuel caps and fills, etc.) we recommend Secraft. Sets which you can
order as order number:
2051000-50 for Hitec servos
2051000-51 for Futaba servos
2051000-52 for JR servos.
Here is list of Secraft parts for linkage:
Servo arm D40 mm (for aileron and elevator)
6
Double servo arm Offset D90mm (for rudder)
1
Double
servo arm D64mm (for rudder)
1
SEC Ball links M3 (10)
1
SEC M3 Push rod of ALU 60 mm (for elevator)
1
SEC M3 Push rod of ALU 70 mm (for aileron
and rudder)
3
For rudder is higly recommended SECRAFT rudder pull-pull set BASE No.: 2050130-01
or SPORT set No.: 2010130-02
2. General informations
 all nuts should be secured against looseninig (use Loctite 243)
 make sure, that all control surfaces can move freely
 all holes drilled in airplane surfaces, that is not factory made, must be reinforced (with
rowing, plywood, etc.)