REAR PADDLES CUSTOMIZATION
1. Select profile 1 or 2 with the rear MODE switch. You can store up to 2 differents
configurations.
2. Select Program with the rear switch. (Normal mode disables the programmed paddles)
3. To program paddles press and hold SET button for 3 seconds, RGB lighting bar starts
flashing.
Then press the selected button to map (X for example) and then press the selected
paddle from M1 to M4 to store the mapped button. Lighting bar stop flashing and the
program is completed
All the buttons except SHARE, OPTIONS, PS and TRIGGERS can be mapped.
The default configuration is:
M1 / X
M2 /
M3 /
M4 /
To Next Page
Loading...