Krone XXL-RGD User Manual

VI - 6
Maintenance
6.7 Maintenance instructions for
the hydraulic system
6.7.1 High-pressure filter
All Series XL feeder wagons with the operator-friendly
hydraulic unit are fitted with a high-pressure filter in the
high-pressure pipework to the valve unit.
Change the filter (3) after each season.
Changing the filter element
• Switch the hydraulic system to the non-pressurised
state.
Place a vessel of sufficient capacity
underneath to hold the escaping oil.
• Slacken the filter bottom section (4) using screw
wrench SW27.
• Remove the filter bottom section (4) and shake out the
remaining oil.
• Clean the filter bottom section (4).
• Pull out the old filter element (3).
• Push the new filter element (3) onto the valve collar.
• Check the O-ring (2) on the filter bottom section (4).
If the O-ring is damaged, replace it with a
new one.
• Replace the filter bottom section and screw it in.
• Tighten to the end stop in the filter top section (1).
• Pressurise the hydraulic system and check for leaks.
OUT
IN
4
3
5
2
1

Krone XXL-RGD Specifications

General

Brand	Krone
Model	XXL-RGD
Category	Tractor Accessories
Language	English