TECHNICAL SPECIFICATIONS:
dimensions: 22 in (W) x 14 in (D) x 11 in (H)
56 cm (W) x 36 cm (D) x 28 cm (H)
weight: 90 lbs / 41 kg
crate dimensions: 25 in (W) x 17 in (D) x 15 in (H)
64 cm (W) x 43 cm (D) x 38 cm (H)
shipping weight: 120 lbs / 55 kg
rotational speed: 33.3 rpm and 45 rpm
tonearm lenght: 9 to 12 inches
power supply: dual channel pure class A linear DC
ac voltage input: 110V or 220V factory set
dc voltage output: 0 to 5 volt, dual cpu controlled, factory calibrated
dc transmission: pico 3 pin cable
data input/output bus: RS232
transmission: pico 4 pin cable
motors: 2432 precious metal brushes dc motors (qty 2)
motor mounts: delrin enclosure, height adjustable
speed guidance system: continuous open loop feedback
sensors type: optical diode I/O (each platter)
correction cycle: every two rotations. 1.5% max. 0.05% min.
monitoring: twin real time speed LED display
command input type: 1 capacitance sensor on/off (left)
1 capacitance sensor 33/45 (right)
platters type: composite layers and encapsulated, balanced
platter weight: 30 lbs / platter
drive: 3 silicone/viton 1.8 sting belts / platter
compensation pulley: teflon and chrome steel bearing
lubricant: synthetic grease
sevice interval: 1 year (clean and re-grease)
main bearings: dual hydraulic isolated inverted sleeve and ball
shaft type: grounded heat hardened tool steel pvd coated
ball type: ceramic top platter, steel lower platter
lubricant: 8 ml. variable viscosity synthetic oil
service interval: 5 years (clean and re-oil)
suspension: full floating top suspended
elastomers: 317 o-rings , viton/silicone mix
service life: lifetime
To Next Page
Loading...