20
Owner’s manual
EN
REAR VIEW
1. VGA port
2. IR receiver
3. Ventilation outlets
REMOTE CONTROL
1. Power button
2. Backward
3. Directional buttons (up, down, left, right)
4. Source selection
5. Volume control
6. Mute
7. Forward
8. Play/pause
9.
10. Exit
11. Menu
12. Volume control
Projector's lamp is subject to wear out. It's brightness over the period of normal using may
decrease and be lower than in the new device.
To maintain lifespan of the lamp, do not unplug device suddenly from the power supply!
Do not disconnect the projector from the power supply mains if the vents are still working.
Do not use the projector non-stop!
Do not pack up the device until it’s fully cooled down!
Before using your device, select an appropriate spot for the projector. Follow instructions and
hints below for optimum usage.
VOL+VOL-
To Next Page
Loading...
Need help?
General