4
Thank you for choosing an appliance from the KRUPS range, which is intended
exclusively for boiling water.
USING YOUR APPLIANCE FOR THE FIRST TIME
DESCRIPTION
Before rst use, rinse the interior of your kettle and boil 1 or 2 lots of water.
Place the base of your kettle on a stable surface and plug it in.
Remove the kettle from its base and ll it via the pouring spout (e) (1) or via the open
lid by pressing the lid opening control (d) and lifting the rear section (2).
Keep the water level within the MAX (1.7 l) and MIN (0.3 l) markings on the indicator
(h) (1).
Check that the lid is rmly closed to prevent any spilling, escape of steam or faulty
operation. Automatic locking is indicated by means of a “click” and the opening
control (d) (3) pops up.
Switch on by positioning the switch (a) to “I”, and the indicator light (b) will come on (4).
Important:
The appliance switches off automatically once the water reaches boiling point, the
switch (a) returns to position “0” and the indicator light (b) goes out (5).
You can also stop the kettle at any time during the heating cycle by setting the switch
(a) to position “0”.
The appliance is protected by a safety device which regulates the heating cycle if the
kettle is switched on with too little water or no water at all. Pour cold water into the
appliance, or wait for a few minutes to restart the heating cycle.
LIMESCALE FILTER (DEPENDING ON MODEL)
Depending on the hardness of the local water, a layer of limescale may form inside your
kettle. If this happens, when the water boils, particles of limescale may be found in
the water you pour. To prevent this from occurring, we have equipped the kettle with a
special limescale lter which retains the particles of scale when you pour water.
Avoid pouring water too quickly, so as to allow it to ow slowly through the
limescale lter.
To remove the limescale lter, lift the kettle away from its base and allow the appliance
to cool down. Never remove the lter when the appliance is full of hot water.
CAUTION: the safety precautions are part of the appliance. Read them carefully
before using your new appliance for the first time. Keep them in a place where you
can find and refer to them later on.
A On / off switch (I/0)
B Indicator light
C Locking and hinged lid
D Lid opening control
E Pouring spout
F Limescale lter (depending on model)
G Body
H Water level indicator
I Power base with integrated cord
storage
J Handle
To Next Page
Loading...
Need help?
General
