13
ENGLISH
BEFORE USING FOR THE FIRST TIME
USE
Remove all various packaging, stickers or accessories from both the inside and outside of
the kettle (do not forget to remove the transparent protective lm from the screen).
Adjust the length of the cord by winding it under the base. Wedge the cord into the notch.
(g. 1)
Before rst use, rinse the kettle. Boil water at maximum capacity 2 or 3 times. Throw away
the water.
1. Place the base on a at, stable, heat-resistant surface away from water splashes
and any sources of heat.
Kettle is only to be used with the base provided.
2. Fill the kettle with the desired amount of water. (g 3)
Never ll the kettle when it is on its base.
Do not ll it above the maximum level (40.57oz / 1.2L), or below the minimum level
(16.91oz / 0.5L). If the kettle is too full, boiling water may spill out (g 4).
Do not use without water.
Check that the lid is closed properly before use (g 5).
3. Position the kettle on its base. Plug it into the outlet.
4. To start the kettle
Place the kettle on the base, the KEEP WARM INDICATOR will briey illuminate in red
and the LED DISPLAY will show the current temperature. Press either the + or - buttons
and the last use temperature / default temperature will be displayed. (g 7).
DESCRIPTION
KETTLE:
A Body
B Gooseneck spout
C Handle
D Lid
CONTROL PANEL
E LED display
shows the water temperature in the
kettle
F START/STOP button
Press to start or stop the boiling cycle
G + button
Press to increase the temperature
H – button
Press to decrease the temperature
I Timer
Press to start or stop the timer
J Keep warm indicator
When lit, the kettle is maintaining the
water temperature for up to 30 minutes
To Next Page
Loading...
