■ The increase in pressure is constantly renewed; the coffee will flow by alternation.
■ The flow of coffee is finished when coffee no longer drips from the permanent filter for about ten seconds.
■ When the cycle is finished, press the safety button and simultaneously raise the locking lever GENTLY to
release any residual pressure. Fig. 11 Remove the glass jug.
Attention: Do not touch the stainless steel machine parts: the water tank (G) and the lid of the
filter (C). You are likely to burn yourself especially when pouring the coffee.
■ Sometimes there can be a cloudy appearance to the coffee due to the water quality, the type of grounds
used or its degree of fineness. We recommend that you stir the coffee in the glass jug. Serve it.
■ If the coffee cycle takes significantly more time than usual, please carry out the descaling of the machine.
(see paragraph DESCALING).
AUTOMATIC STOP
■ Your device will automatically turn off approximately 20 min after the start of the cycle.
STORING THE POWER CORD
This coffee maker is equipped with a practical system of winding the cord underneath the unit. Fig. 12
CLEANING
■ Never immerse the body of the appliance in water. Always unplug and allow the appliance to cool before
cleaning.
■ The water tank and heater are made of stainless steel and therefore it is easy to clean.
■ Clean the water tank with a soft cloth or damp sponge. Do not clean the appliance when it is still hot.
■ Do not attempt to remove incrustation with abrasive objects or materials; they can be lodged in the pipe
and the plug (see the paragraph “descaling”).
■ Wash the glass jug, lids and filter holder in hot water and washing-up liquid then rinse thoroughly and
carefully.
■ Occasionally, loosen the knob on the bottom of the lid of the filter and clean the interior part of the lid. Fig.
13 et 14
REPLACEM E NT OF TH E GASKET
■ After a certain period of use, the lid of the water tank, the filter holder or hot water pipe may no longer
close properly. This is due to the deterioration of the gasket. To replace them, contact The Customer
Relations Department, see Contact list
DESCALING
■ Why descale
The scale is naturally deposited in your coffee maker. Descaling preserves the coffee maker and ensures it
a longer life. Descaling ensures a consistent quality of coffee in time. The scale may permanently deteriorate
the performance of the machine. The malfunctions related to the scaling will not be under guarantee if you
return the product.
■ How to descale
By using the descaling kit or white vinegar.
■ When to descale
The frequency of descaling depends on the water hardness and the number of coffee cycles. When the
following signs are encountered: cycle time lengthened, high evaporation, high level of noise at the end of
cycle, stop during the cycle, it signifies that your machine is calcified.
English
10
To Next Page
Loading...
