11
• Plug the machine into a grounded electrical
socket. Verify that the voltage indicated on
the technical specifications on the bottom of
the unit corresponds to your electrical
installation.
• Ensure the drip tray and drip tray grind are
in place when using the machine.
Before using your appliance for the first time,
clean the system completely as follows:
• Open the lid and lift out the water container
using the handle (1). Fill the water container
with fresh, cold water (2).
• Place the water container back into the
appliance by positioning it firmly in the
water container compartment (3) and close
the lid.
• Turn on the appliance (4). The blue
operating light and the orange temperature
control indicator light will both come on.
Two filters are set in the tank lid.
• Place one of the filter baskets in the filter
holder (5). Then put the filter holder up
against the appliance’s brewing head.
• To ensure that the filter holder is in the
correct position, turn the handle so it points
to the left at a 45 degree angle (6), place
the filter holder flat against the brewing
head, then turn the handle towards the right
(7) as far as it can go.
• Place a container, as large as possible,
beneath the filter holder (8).
• As soon as the orange indicator light goes
off, turn the selector to the
setting (9)
and allow all the water in the water tank to
run through.
• If necessary, you can stop the operation by
turning the selector to the O setting to
empty the container, then resume operation.
• It is recommanded to rinse the system 2
times prior to first use.
As an accessory, there is a filter cartridge
(N° art. F088) not delivered with the
appliance.
Using the various functions of
your espresso machine
1. ESPRESSO MAKING
. WITH GROUND COFFEE
For best results, we recommend that you first
pre-heat the accessories (filter holder, filter
basket and cups) without putting in
ground coffee. To do this :
•Fill the water container with fresh, cold
water (1) (2) (3) and turn on the appliance
(4).
•Put the filter holder and an empty filter
basket in place (6) (7), and place the
espresso cups underneath.
•As soon as the appliance reaches the correct
temperature the orange indicator light will
go out.
• Turn selector to the setting (10).
• When the cups are full of hot water, reset
the selector to the O setting.
After making your first espresso and the
appliance is hot, the espresso cups can then
be pre-heated on the cup warming plate.
. Preparing an espresso :
•Fill the water container (1) (2) (3) and turn
on the appliance (4).
•Put the filter basket for one or two cups into
the filter holder (5) .
•Place some ground coffee in the filter basket
(1 or 2 measuring scoops), and then tamp it
down firmly; the coffee should reach the lip
of the filter (11) (12).
•Remove any ground coffee which is lying
around the filter (13).
•Replace the filter holder into the machine.
Turn the filter holder until it is firmly locked
into place (6) (7).
•Place one or two espresso cups beneath the
filter holder.
As soon as the appliance reaches the correct
temperature the orange indicator light will go
out.
•Then turn the selector to the
setting (9)
(10).
•When the cups are full, reset the selector to
the O setting.
XP 4000 US/F/E PM6.5 13/10/04, 11:0311
To Next Page
Loading...
Need help?
General
