English
84
To descale your coffee maker, you can use:
- either a sachet of descaler from the stores diluted in 250ml of water
- Or 250 ml of white vinegar available from hardware stores.
Pour the descaler or vinegar in the water compartment and turn the coffee maker on (without filter
and without ground coffee).
Let half of this mixture run through into the jug then turn the appliance off by pressing the "On / Off"
button.
Leave for one hour.
Turn the appliance back on by pressing the "On / Off" button and let the rest of the water run through.
Rinse the coffee maker by running two jugs of fresh water through.
The guarantee does not cover coffee makers that do not work properly or do not work at all
because they have not been descaled.
-
Problems Solutions
The coffee maker does not come on: Check the connection
There seems to be a leak:
Make sure the water tank was not filled beyond the
limit
The water takes too long to run through
or the appliance makes excessive
noise:
Descale your appliance.
Your appliance still does not work? Contact a Krups approved service centre.
IN CASE OF PROBLEM:
END OF LIFE ELECTRICAL AND ELECTRONIC PRODUCT
Environmental protection first!
Your appliance contains a lot of recoverable or recyclable material.
When disposing of it, take it to a collection point or an approved service centre.
Helpline:
0845 602 1454 - UK
(01) 677 4003 - ROI
web site: www.krups.co.uk
To Next Page
Loading...
