Krups XP320830 User Manual

9
ENGLISH
PROBLEMS POSSIBLE CAUSES SOLUTIONS
The espresso is not frothy. The coffee grounds are too
old.
Use freshly ground coffee.
The ground coffee is
not suitable for making
espresso.
Use ner grounds.
There is too little coffee in
the lter holder.
Add more coffee.
The water tank leaks when
it is moved.
The valve at the bottom
of the tank is dirty or
defective.
Wash the water tank and
operate the valve with your
nger, which is beneath the
tank.
The valve is blocked by the
calcied deposits.
Descale your machine
following the user
instructions provided.
Water leak beneath the
appliance.
There is an internal leak. Check that the tank is
positioned correctly. If
the problem persists, do
not use the appliance and
consult an approved service
centre.
The pump is abnormally
noisy.
No water in the tank. Fill the water tank and
restart the pump (refer to
the section: FIRST USE).
Avoid emptying the tank
completely.
The espresso leaks out the
sides of the lter holder.
The lter holder is not
positioned correctly.
Fit the lter holder in
position and lock it (turn
from left to right until it
stops).
Remove any excess coffee
that prevents you from fully
locking the lter holder.
The edge of the lter holder
is clogged by the coffee.
Remove the excess coffee
and clean the grill through
which the water ows using
a damp sponge.
Your espresso tastes bad. After descaling, the rinsing
cycle was not carried out
correctly.
Rinse the appliance in line
with the user instructions
and check the quality of the
coffee.

Krups XP320830 Specifications

General

Brand	Krups
Model	XP320830
Category	Coffee Maker
Language	English