EasyManua.ls Logo

Krups XP3440 - Page 33

Krups XP3440
158 pages
Go to English
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
30
English
PROBLEMS POSSIBLE CAUSES SOLUTIONS
Water is leaking under the
appliance.
There's an internal leak. Check that the tank is
tted correctly. If the leak
continues, do not use
the appliance, contact an
approved service centre.
The drip tray has not been
tted correctly.
Check that the drip tray is
pushed to the back of the
appliance.
The drip tray is overowing. Empty and carefully rinse
the drip tray and replace.
The cups have been lled
unequally.
The lter holder is clogged. Please refer to the
paragraph on CLEANING
AND SERVICING for
servicing your lter holder.
The pump is abnormally
hot.
There is no water in the
tank.
Fill the tank with water
and re-initiate the pump
(see paragraph: USING
FOR THE FIRST TIME).
Avoid emptying the tank
completely.
The espresso leaks over
the edges of the lter.
The lter holder is not
positioned correctly.
Put the lter holder in place
and lock it (turning it from left
to right as far as it will go).
Remove excessive coffee
grounds that prevent the
lter holder to be locked.
The rim of the lter holder
is encrusted with coffee
grounds.
Remove excessive coffee
grounds and clean the grid
through which water passes
with a damp sponge.
The soft capsule is
positioned incorrectly.
Check that the soft
capsule has been inserted
correctly: the paper must
not protrude out of the
lter.
Your espresso tastes bad. The appliance was not
rinsed correctly after
descaling.
Rinse the appliance
according to the
instructions and check the
quality of the coffee.

Table of Contents

Other manuals for Krups XP3440

Related product manuals