KT RECOVERY+ WAVE - User Manual

To Next Page

Locate your point of pain at the base of

the neck and center the KT Wave™ over

it. Use 2-3 adhesive strips to secure the

loop to your skin.

Locate your point of pain and center the

KT Wave™ over it. Use 2-3 adhesive

strips to secure the loop to your skin.

Place the KT Wave™ on your shoulder,

centering the loop over your point of

pain. Secure the loop to your skin on

both sides using the adhesive strips.

Placement may vary.

Locate your point of pain and center the

KT Wave™ over it. Use 2-3 adhesive

strips to secure the loop to your skin.

*Can also be worn under clothing.

Place the KT Wave™ on the back of your

hand, centering your point of pain

within the loop. Use 2-3 adhesive strips

to secure the loop to the forearm and

back of the hand.

Sitting with your knee bent, place the

KT Wave™ over the joint with your pain

point in the center. Use 2-3 adhesive

strips to secure the loop in place.

With your elbow bent, place the KT

Wave™ over the outside of the joint

with your pain point in the center. Use

2-3 adhesive strips to secure the loop in

place on the upper and lower arms.

Locate your point of pain and center the

KT Wave™ over it. Use 2-3 adhesive

strips to secure the loop to your skin.

Avoid placing adhesive strips directly

over the back of the knee.

Locate your point of pain and center the

KT Wave™ over it. Use 2-3 adhesive

strips to secure the loop to your skin.

Locate your point of pain and center the

KT Wave™ over it. Use 2-3 adhesive

strips to secure the loop to your skin. .

Avoid placing the device module under

the sole of your foot. May also be worn

over foot.

TRIM HAIR

Trim excessive hair for better adhesion.

CLEAN SKIN

Clean dirt, oils and lotions from

area with rubbing alcohol

APPLY BEFORE ACTIVITY

Apply tape one hour before

beginning activity.

DON’T RIP OFF!

Gently remove tape from skin, use

baby oil if necessary and remove slowly.

WATCH VIDEOS FOR HELPFUL TIPS

Visit kttape.com/instructions to view our full

database of easy-to-follow product tutorials.

END ON SKIN, NOT ON TAPE

Apply directly to skin when possible,

especially the ends.

The electronics and

battery are in this module.

Green light illuminates

when device is turned on.

Therapeutic area

is inside loop.

To apply strips without touching adhesive:

1. BEFORE YOU START

2. HANDLING TAPE

3. HOW TO TURN DEVICE ON & OFF

4. COMMON APPLICATION SITES

APPLY MIDDLE FIRST

wave

ELECTROMAGNETIC PAIN RELIEF

RECOVERY

How to turn the Device On:

Step 1: To activate the device, remove

the white tab from the back of the

device and push the silver on/off button

for 1-2 seconds. Release the button.

*Throw away white tab.

Step 2: Once the device is activated,

the green LED light on the front of the

device will turn on. If the green LED

light does not turn on, please repeat

Step 1.

How to turn the Device Off:

To deactivate the device, press the

silver button and hold it down for 1-2

seconds. Once the device is

deactivated, the green LED light will

turn off.

KNEE BACK OF KNEE FOOT

BASE OF NECK

LOWER BACKUPPER BACK

SHOULDER HAND ELBOW HIP

www.kttape.com

Peel

Peel backing paper

slightly on each side

for easy handling.

www.kttape.com

Open

Open backing paper

at center perforation.

Apply

Apply as shown over

loop wire.

www.kttape.com

Center KT Wave™ over

pain point and secure

it with adhesive strips.

Place

www.kttape.com

WARNING: For external use only. Do not use this product if you have poor circulation, or are diabetic. Do not use if you are allergic to any component of this

product. Do not apply to any infected areas. Only apply each strip one time. Discontinue use if skin becomes irritated. Do not use product if paper backing has

been damaged or removed. This product is not made with natural rubber latex.

NOTE: Store away from sunlight in a dry, cool environment between 40°- 80°F . Questions? Email us at

support@kttape.com

ADHESIVE TAPE

™

*Can also be worn under clothing.

On/off button

on back of device

Need help?

Do you have a question about the KT RECOVERY+ WAVE and is the answer not in the manual?

Summary

Preparation and Safety Before Use

Pre-Activity Tape Application

Apply tape one hour before beginning activity for optimal adhesion and effectiveness.

Skin Preparation and Hair Trimming

Clean skin with rubbing alcohol and trim excessive hair for better tape adhesion.

Adhesive Tape Usage Warnings

Important warnings for external use, circulation, diabetes, allergies, and skin irritation.

Proper Tape Removal Technique

Gently remove tape from skin, using baby oil if necessary, and remove slowly.

Helpful Instructional Videos

Access a database of easy-to-follow product tutorials and helpful tips online.

Handling and Applying KT Wave Tape

Applying Tape Without Touching Adhesive

Steps to apply the KT Wave tape by first applying the middle section to avoid touching the adhesive.

Step-by-Step Tape Placement

Instructions for opening, peeling, applying, and centering the KT Wave over the pain point.

Device Operation Guide

Turning the KT Wave Device On

Activate the device by removing the white tab and pressing the silver on/off button for 1-2 seconds.

Turning the KT Wave Device Off

Deactivate the device by pressing and holding the silver button for 1-2 seconds until the green light turns off.

Common Application Sites Overview

Base of Neck Application

Locate pain point at the base of the neck and center KT Wave; secure with 2-3 adhesive strips.

Shoulder Application

Center KT Wave over shoulder pain point and secure with adhesive strips on both sides.

Hand Application

Place KT Wave on the back of the hand, centering pain within the loop, and secure to forearm and hand.

Elbow Application

With elbow bent, place KT Wave over the outside of the joint, centering pain, and secure to arms.

Hip Application

Locate pain point and center KT Wave over it; secure with 2-3 adhesive strips to your skin.

Upper Back Application

Locate your point of pain and center the KT Wave over it. Use 2-3 adhesive strips to secure.

Lower Back Application

Locate your point of pain and center the KT Wave over it. Use 2-3 adhesive strips to secure.

Knee Application

Sitting with knee bent, place KT Wave over the joint, centering pain, and secure to leg.

Back of Knee Application

Locate pain point and center KT Wave; secure with strips. Avoid placing strips directly over the back.

Foot Application

Locate pain point and center KT Wave; secure with strips. Avoid placing module under sole.

Additional Application Sites and Product Information

Comprehensive Application Site List

Lists various anatomical locations for KT Wave application, including less common sites.

General Application Guidance

KT Wave can be applied over any joint or tissue for pain relief; find more instructions online.

Explore KT Tape Product Range

Information and links to learn about related KT Tape products like pain relief gel and performance tape.

KT RECOVERY+ WAVE Specifications

General

Brand	KT
Model	RECOVERY+ WAVE
Category	Personal Care Products
Language	English