Base And Wall Mount
1. Installing the Base:
o, Install the base onto the stand and fasten it with
the thumb screw from the bottom of the base;
b, Tilt the base in the direction of the second arrow
and install it into the backshell hole,Then press and
lock the whole base in the direction of the third arrow.
2. If you want to remove the whole base,
do the following:
a, Push the quick release button which is neor the
VESA;
b, Remove the whole base in the direction of the
arrow,
Rotate the lifting support
to make the screen
horizontal or vertical
Use M4 screws 100x100mm
Recommended screw length is 8mm
o
O
€9.
Rotate to left or right for 450
Wall
Rotate the
support to
the screen
toward up,
lifting
moke
pitch
down,
+200
150mm
(If you need wall mounting bracket, you need to buy it separately)
left, right, front, or
bacl< directions
100mmx100mm
To Next Page
Loading...