Power Management System
Mode
Normal Operation
Standby
Power Consumption
s65W
so.5W
Remark: All technical specifications in the User Guide and on the external packing are allowed to
change without prior notice. If there is o subtle difference between the User Guide and the actual
operation, the latter shall prevail.
6.1nstruction for base installation
1. Installing the Base:
o. Install the base onto the stand and fasten it with two M4x16 screws;
b. Tilt the base in the direction of the second arrow and fasten it with four M4x16 screws.Then
press and lock the whole base.
O
2. If you want to remove the whole base, do the following:
a. Push upward the slider near the VESA cap on base;
b. Lift and take out the base along the arrow direction.
o
7
To Next Page
Loading...