Base And Wall Mount
1. Installing the Base:
a. Install the base onto the
stand and fasten it with two
M4x16 screws;
b. Tilt the base in the direction
of the second arrow and
install it into the backshell
hole.Then press and lock the
whole base in the direction of
the third arrow.
2. If you wont to remove the whole base, do the following:
oo
O
a. Push upward the
slider near the VESA
cop on base;
b. Lift and take out
the base along the
arrow direction.
Use M4 screws 100x100mm
Recommended screw length is 8mm
O
wall
(If you need wall mounting bracket, you need to buy it separately)
100mmx100mm
To Next Page
Loading...