6. Prefix code setting
6.1 Press and hold SET key over a few seconds, LCD display
“SEt 1 dAtE”, then press UP twice, LCD shows “SEt 3
PCOdE”
6.2 Press the SET key again, the LCD show “PCOdE - ”
6.3 Press UP or DOWN to set one digit of Prefix code (from 0 ~ 9).
6.4 Press SET to confirm and exit.
After setting of Prefix code, when you press REDIAL or
RD/ARD key to call back the Caller ID memories, Dial-out
memories or Pre-dialing numbers, this phone will dial the Prefix
Code firstly, then dial out the numbers.
7. IP code setting
7.1 Press and hold SET key over a few seconds, LCD display
“SEt 1 dAtE”, then press UP three times, LCD shows “SEt 4
AUtO IP”
7.2 Press the SET key again, the LCD show “AUtO IP OFF”
7.3 Press UP or DOWN to set “AUtO IP ON”, then press SET
key once.
7.4 LCD display “INPUt COdE”
7.5 Press number key to input IP code.
7.6 Press SET to confirm and exit.
After setting of IP code, when you press REDIAL or RD/ARD
key to call back the Caller ID memories, Dial-out memories or
Pre-dialing numbers, if the first digit of these numbers is “0”,
then this phone will dial the IP Code firstly, then dial out the
numbers.
8. Alarm clock setting
8.1 Press and hold SET over 3 seconds, LCD shows “set 1 date”,
then press UP four times, LCD shows “set 5 alert’
8.2 Press SET key again, the LCD shows “ 00-00 off”, the “00”
(Alarm Clock Hour time) on the LCD begins to flash.
8.3 Press UP or DOWN to set the Alarm Clock Hour time.
13
To Next Page
Loading...