IMPORTANT INFORMATION 9
The current KTM PowerParts for your vehicle can be found on the KTM website.
International KTM Website: http://www.ktm.com
Work rules
Special tools are needed for certain tasks. They are not included with the vehicle but can be ordered under the number in parentheses.
E.g.: valve spring mounter (59029019000)
When assembling the equipment, non-reusable parts (e.g. self-locking screws and nuts, seals, seal rings, O-rings, pins, lock washers) must
be replaced with new parts.
If a thread locker (e.g. Loctite
®
) is used for screw connections, follow the instructions for use from the manufacturer.
Parts that are to be reused after being disassembled should be cleaned and checked for damage and wear. Replace damaged or worn
parts.
After finishing the repair and maintenance work, ensure that the vehicle is roadworthy.
Transport
Note
Danger of damage Danger of damage from accidental rolling of vehicle.
– Park the vehicle on a surface that is as horizontal as possible and apply the parking brakes.
Note
Fire hazard Some vehicle components become very hot when the vehicle is operated.
– Do not park the vehicle near flammable or explosive substances. Do not place objects on the vehicle while it is still warm from being
run. Always let the vehicle cool first.
– Switch off the engine.
– Turn the handle of the fuel tap to OFF. (Figure 100013-10 p. 44)
– Use straps or other suitable devices to secure the vehicle against accidents or falling over.
– Fold down the parking brake lever . (Figure 601044-10 p. 22)
To Next Page
Loading...
Need help?
General
