WARNING!
Do not operate your KUBERG if any damage is apparent. Immediately contact your local retailer/
distributor or KUBERG Customer Service.
WARNING!
There are no user serviceable elements incorporated into the motor, motor controller, batteries,
battery charger, throttle, or wiring harness of your KUBERG electric bike. DO NOT ATTEMPT
TO DISASSEMBLE OR ADJUST ANY OF THESE COMPONENTS. Doing so may cause extensive
damage to these components, will void your warranty, and may result in danger to persons and/
or property. If you cannot resolve any problem using this owner’s manual, contact your KUBERG
authorized dealer, or call the KUBERG Customer Service for assistance.
FRONT WHEEL REMOVAL AND INSTALLATION
1
Make sure the power is switched o.
2
Lift the bike onto a block or stand so that both wheels are o the ground.
3
On Kuberg Start, disconnect the V-Brake cable by squeezing the two sides together and
release the cable end from the mount. (Kuberg Trial E and Kuberg Cross have disc brakes
which do not require this step)
4
Loosen the axle bolts and lower the wheel away from the front forks.
5
To re-install the wheel, reverse the above procedure and ensure the wheel is aligned cor-
rectly and the axle bolts are tight.
6
Spin the wheel to ensure it is centered and spins freely.
REAR WHEEL REMOVAL AND INSTALLATION
1
Make sure power is switched o.
2
Lift the bike onto a block or stand so the wheels are o the ground.
To Next Page
Loading...
