Kubota LA344S - User Manual

Questions and Answers

T
Tiffany WrightAug 7, 2025
What to do if the 3rd function valve on Kubota Front End Loaders does not operate correctly?
- B
  Brenda WilsonAug 7, 2025
  If the 3rd function valve on your Kubota Front End Loader isn't working correctly, the 3rd function valve wiring harness or the valve itself might be damaged and need repair or replacement. Check the battery supply voltage at the front hydraulic valve main switch connector and replace the wiring harness if necessary. Additionally, check or replace the relay.
C
christinafrancoAug 12, 2025
Why won't the boom on my Kubota Front End Loader rise?
- M
  Mark KennedyAug 12, 2025
  If the boom on your Kubota Front End Loader doesn't rise, several issues could be the cause. A damaged control valve, boom cylinder, control lever linkage, or hydraulic pump could be responsible, requiring repair or replacement. Alternatively, a damaged relief valve spring needs replacement, or a dirty relief valve needs cleaning. A clogged oil filter should be cleaned or replaced, and a damaged hydraulic hose should be replaced.
M
Michael HintonAug 17, 2025
What to do if the bucket on my Kubota LA344S Front End Loaders does not move?
- P
  Patrick WadeAug 17, 2025
  If the bucket on your Kubota Front End Loader won't move, it could be due to several reasons. The control valve, bucket cylinder, control lever linkage, or hydraulic pump might be damaged and need repair or replacement. Additionally, a clogged oil filter should be cleaned or replaced. A damaged relief valve spring needs replacing, and a damaged hydraulic hose should be replaced. Finally, a dirty relief valve should be cleaned.
B
Brandon DixonAug 23, 2025
Why is the boom speed insufficient on my Kubota Front End Loaders?
- J
  Joseph JuarezAug 23, 2025
  If your Kubota Front End Loader boom speed is insufficient, several factors could be at play. The boom cylinder tube or piston ring might be worn or damaged and need replacement. Oil leaks from tube joints should be repaired. If the relief valve setting pressure is too low, it should be adjusted. Ensure that the transmission fluid is sufficient and fill if needed. Lastly, a dirty relief valve should be cleaned.
F
felicia99Aug 28, 2025
Why does my Kubota Front End Loader fall by its weight?
- K
  Kelly EllisAug 28, 2025
  If your Kubota Front End Loader falls by its weight, it could be due to a worn or damaged boom cylinder tube or piston ring, which would need replacement. Oil leaks from tube joints also can cause this issue and should be repaired. A damaged control valve, requiring repair or replacement, might also be the cause.
M
Melissa GlassSep 1, 2025
How to troubleshoot a Kubota Front End Loader when the boom does not lower?
- B
  beverlymaySep 1, 2025
  If the boom on your Kubota Front End Loader does not lower, it could be due to a damaged control valve or control lever linkage, both requiring repair or replacement.