TRANSMISSION
L3540-II, L4240-II, L5040-II, L5240-II, L5740-II , WSM
3-S6
Error Display for GST Model
Display on LCD
Screen
Trouble Item Probable Cause Solution
Reference
Page
Electronic
instrument panel
memory device
has failed
• Electronic instrument
panel memory device
failure
Replace the electronic
instrument panel
9-S36
Communication
error between
ECU and
electronic
instrument panel
• Fuse blown out
• Communication line
between ECU and
electronic instrument
panel is broken or
short-circuited
• No signals from ECU
for longer than
5 seconds (error
cleared if signal sent
and received later)
• ECU damaged
Check the fuse 9-S35
Check ECU connector 9-S42
Check communication
line between ECU and
electronic instrument
panel at ECU
connector
9-S42
Replace ECU 9-S45
ECU memory
device has failed
• ECU memory device
failure
Replace ECU 9-S45
Input voltage to
lever sensor
from ECU is
failed
• Lever sensor input
voltage drop below
2.6 V for 0.1 second or
more
• Ground wire of lever
sensor short-circuited
Check the ground
cable
9-S36
Check input voltage at
ECU connector
9-S45
Check the sensor
connector
–
GST lever
sensor is failed
• Lever sensor output
terminal is out of
adjustment
• Lever sensor output
wire terminal broken or
short-circuited
• Input line broken
• Lever sensor damaged
It is possible to run at
its selected speed
position until engine is
stopped.
–
Check the sensor
connector
–
Check the sensor
voltage by Test mode
(Mode A)
9-S22
Check the lever sensor
wire connector
(voltage) or check the
sensor resistance
9-S46
Replace the lever
sensor
–
To Next Page
Loading...
Need help?
General