Kubota WSM L5040-II User Manual

CABIN
L3540-II, L4240-II, L5040-II, L5240-II, L5740-II , WSM
10-S45
Water Cable, Temperature Motor and Mode Motor
1. Disconnect the water cable (1).
2. Remove the motor screws (2).
9Y1211167CAS0061US0
Air Conditioning Unit
1. Remove the unit cover (1).
2. Disconnect the heater hoses (5).
3. Disconnect the air conditioner pipes (4).
4. Remove the screws and take off the unit.
5. Remove the duct hoses.
(When reassembling)
• When reconnecting the cooler pipes with the unit, apply
compressor oil (NIPPONDENSO OIL8 or equivalent) to O-rings.
• When remounting the unit, tighten five screws by hand and
finally retighten them after aligning the inner roof duct with the
unit duct.
• When connecting the heater hose with A/C unit, hose should be
put into the A/C unit pipe more than 30 mm (1.2 in.)
9Y1211167CAS0062US0
(1) Water Cable
(2) Motor Screw
L: 6 mm (0.2 in.)
Tightening torque
A/C unit mounting screw
(M6)
4.0 to 6.8 N·m
0.40 to 0.70 kgf·m
2.9 to 5.0 lbf·ft
A/C unit mounting screw
(M8)
9.81 to 11.6 N·m
1.00 to 1.19 kgf·m
7.24 to 8.60 lbf·ft
Low pressure pipe (Cooler
pipe (suction)) retaining nut
7.90 to 11.8 N·m
0.806 to 1.20 kgf·m
5.83 to 8.70 lbf·ft
High pressure pipe (Cooler
pipe (liquid)) retaining nut
11.8 to 14.7 N·m
1.21 to 1.49 kgf·m
8.71 to 10.8 lbf·ft
(1) Unit Cover
(2) Evaporator
(3) Heater Core
(4) Air Conditioner Pipe
(5) Heater Hoses
KiSC issued 02, 2015 A

Kubota WSM L5040-II Specifications

General

Brand	Kubota
Model	WSM L5040-II
Category	Tractor
Language	English