Kuhne electronic TR144-PRO User Manual

shop.kuhne-electronic.de
Kuhne electronic GmbH
Scheibenacker 3 Telefon: +49 (0) 9293 / 800640
95180 Berg – Germany E-Mail: info@kuhne-electronic.de
Solutions for the wireless world
TR144-PRO 2 m Linear Transverter
Seite / page 1
Bedienungsanleitung / User Manual
TR144 PRO
2m Linear Transverter
V3.0 - 24.08.2017

Kuhne electronic TR144-PRO Specifications

General

Brand	Kuhne electronic
Model	TR144-PRO
Category	Transceiver
Language	English

Summary

Technical Data and Specifications

Instructions 1: General Information

Instructions 2: Control Elements

Front Panel Controls and Indicators

Identifies and describes front panel controls and indicators.

Instructions 3: Rear Panel Connections

Rear Panel Connectors and Functions

Details rear panel connectors and their functions.

Instructions 4: Fuse and Safety

Fuse and Internal Components

Instructions 5: Power On and Operation

Power On Procedure

Normal Operation Modes

Explains normal operation, display modes, and LED status.

Instructions 6: Configuration Menu

Configuration Menu Introduction

Introduces the menu system for configuring transverter settings.

Instructions 7: Sequencer Timing Configuration

Adjusting Sequencer Time Settings

Explains how to adjust sequencer timing settings within the menu.

Instructions 8: IF Port Configuration

IF Port Configuration Options

Details the IF port configuration (two-cable vs. single-cable solutions).

Instructions 9: TX IF Amplifier Settings

TX IF Amplifier Settings

Explains settings for the transmit IF amplifier (TX IF AMP).

Instructions 10: Antenna Settings Configuration

Antenna Port Configuration Options

Describes antenna port configuration (two-cable vs. single-cable).

Operation 1: Rear Panel Connections (IF)

IF Connectors (IF A, IF B, IF C)

Details IF connectors and their specifications.

Operation 2: Rear Panel Connections (LO/REF)

LO and Reference Input Jacks

Operation 3: Antenna Connections

Antenna Port Wiring and Configuration

Operation 4: Serial Interface

Serial Interface Description and Pinout

Operation 5: DC Power and Control

DC/Control Connector Details and Power Supply

Operation 6: Control Outputs and PTT

Control Outputs and PTT Input Functionality

Operation 7: DC Power Cable Wiring

DC Power and Control Cable Wiring Diagram

Operation 8: Status LEDs (ALC, SWR, PLL)

Operation 9: Status LEDs (TX, Power)

LED Status Indicators Explained

Software 1: Remote Control

Remote Control Introduction and Commands

Software 2: Remote Control Commands (Read)

Read Commands for Status and Configuration

Software 3: Remote Control Commands (Write)

Write Commands for Settings

Software Update

Firmware Update Procedure

Troubleshooting

Troubleshooting Checklist

A troubleshooting checklist for common issues and their potential causes.

Block Diagram