Operating instructions
Automatic start/stop system for stand-alone gensets
For product: KEA 292 INS
File: BA_KEA 292 INS_EN_Ver 2016-07-01.doc Item no.
2A292I5000
Telephone: +49 4171-798-0
Subject to technical changes.
An der Kleinbahn 39,21423 Winsen
Fax: +49 (0) 4171-798-117
_________________________________________________________________________________
1. Use and basic operation
The KEA 292 INS automatic system is used for power generation units that operate in standalone
mode.
The function of the output relay and the parameters can be set with a PC.
Because the KEA 292 has the same dimensions and fastenings as its predecessor, replacement is
simple.
Ten parameterisable alarm and operating indicators – which can be labelled by easily replaceable
paper strips – as well as four general displays are displayed through LEDs.
The parameterisation can be performed using the serial USB interface with the PARAWIN parameteri-
sation program.
Important note!
The operation of the automatic system is simple and uncomplicated as it is carried out via the usual
buttons – without menu guidance – as for all previous automatic systems.
2. Revision history
Connection diagrams updated
To Next Page
Need help?
General