EasyManua.ls Logo

KUKUI QUANTUM - Operation Guide; Getting Started; Refilling Fragrance; Operational Notes

KUKUI QUANTUM
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
13
NOTES ON OPERATION
PLACEMENT
The fragrance distributes in the room according to the natural air circulation.
The device should be placed in a place where the air circulation favors the
fragrance distribution.
SCENT INTENSITY
The optimal strength control depends on the air circulation in the room. In
rooms with ventilation systems or open doors/windows, a higher fragrance
strength may be required than in closed rooms.
INTERVAL CIRCUIT
The unit works for a few minutes (working interval) and then switches off
automatically for a short moment (pause interval). After this pause interval has
elapsed, the working interval follows again.
FRAGRANCE OIL
The fragrance quality of the perfume oil in the bottle will remain unchanged
for at least 6 months whilst in use. In case of a longer period of time, the heart
of the fragrance may have evaporated even if there is still liquid in the bottle.
In this case, we recommend checking the fragrance quality and replacing the
bottle if necessary.
OPERATION
1 Place the unit on a at, solid oor.
2 Open the door with the key supplied.
3 Screw the fragrance bottle type Q (200 ml) (available separately) into the holder.
Slide the riser tube into the glass and slowly turn it counterclockwise until it stops.
4 Set the desired intensity control
(1=weak to 10=strong)
5 Plug in the power cable of the unit.
6 Push the power button.
The control lamp lights up. The appliance is now in operation.
7 Close the door.
8 To switch off: Push the power button.
The unit can also be easily disconnected from the mains (e.g. via relay or timer).
Caution: If fragrance is inserted, only move the device horizontally!
1 Open the door with the supplied key.
2 Switch off the appliance by pushing the power button. The control lamp goes out.
3 Loosen the fragrance glass clockwise and lift it out.
4 Screw a new fragrance glass (bottle type Q, 200 ml) into the holder: let the riser tube
slide into the glass, slowly turn it counterclockwise until it stops.
Note: Cleaning is not necessary even when inserting a new fragrance type.
5 Push the power button.
The control lamp lights up. The appliance is now in operation.
6 Close the door.
HOW TO REFILL OR CHANGE FRAGRANCE