Kunft KCHS4852 IX - Maintenance

14 15
KCHS4852 IX
KCHS4852 WH
EN
visor cooker hood
INSTALLING GREASE MESH FILTERS
• To install lters for the following four steps .
- Angle the lter into slots at the back of the hood.
- Push the button on handle of the lter.
- Release the handle once the lter ts into a resting position.
- Repeat to install all lters.
2.3. Maintenance
Changing and cleaning the filter:
Remove the lters as shown in the instructions of Picture 10;
• You can clean the lter through the following method:
1. Soak them for about 3 minute in hot water (40-50 degrees) with a
grease loosening detergent, and brush it gently with a soft brush.
Please, do not apply too much pressure to avoid damaging it.
2.
It can be put in the dishwasher with detergent, set the tempera-
ture at around 60 degrees.
• Please do not use abrasive detergents for they will damage
the hood;
• Make sure that the hood is switched off before cleaning it;
• Clean the lters after approximately 30 hours of use, or at least
once a month.
2.2.3. Troubleshooting
Fault Possible Cause Solution
Light on, but motor
does not work
Fan switch turned
off.
Select a fan switch
position.
Fan switch failed. Contact service center.
Motor failed. Contact service center.
Light does not work,
motor does not work
House fuses blown. Reset / Replace fuses.
Power cord loose
or disconnected.
Ret cord to power
outlet.
Switch power outlet on.
Oil leakage One way valve and
the outlet are not
tightly sealed
Take down the one way
valve and seal with
sealant.
Leakage from
the connection of
chimney and cover.
Take chimney down
and seal.
Lights not working Broken / Faulty
globes.
Replace globes as per
this instruction.
Insufcient suction The distance
between the cooker
hood and the gas
top is too far.
Ret the cooker hood to
the correct distance.
The Cooker hood
inclines
The xing screw
not tight enough.
Tighten the hanging
screw and make it
horizontal.