Why is the suction power not sufficient on my Kuppersberg Ventilation Hood?
If the suction power of your Kuppersberg Ventilation Hood isn't strong enough, the speed setting might be too low. Try increasing the suction speed. Also, the filters could be clogged, so cleaning or replacing them is recommended.
What to do if my Kuppersberg Ventilation Hood does not operate?
If your Kuppersberg Ventilation Hood isn't turning on, start by checking the appliance's fuse. Also, ensure the plug is fully and correctly inserted into the outlet. Finally, verify that there is voltage in the power supply system.
How to fix the lamp if it is not lighting on my Kuppersberg Ventilation Hood?
If the lamp in your Kuppersberg Ventilation Hood isn't lighting, first check the appliance's fuse. If the fuse is fine, make sure that the lamp is installed correctly or replace it.
How to fix the lamp if it is not lighting in Kuppersberg Ventilation Hood?
If the lamp in your Kuppersberg Ventilation Hood isn't lighting, check the fuse of the appliance. Also, make sure the lamp is installed correctly or replace it if it's burned out.
General| Mounting | Wall-mounted |
|---|---|
| Width | 90 cm |
| Number of Speeds | 3 |
| Number of Lamps | 2 |
| Grease Filter | Yes |
| Motor Quantity | 1 |
| Operating Mode | Exhaust / Recirculation |
| Filter Type | Aluminum |
| Material | Stainless steel |
To Next Page
