en
24
Adding Rinse Aid
You can set the amount of rinse aid
added.
If the option “Adding Rinse Aid” is
chosen the display shows “Rinse Aid 4”
(factory setting).
Change this setting only if there are
streaks (reduce the value) or water
stains (increase the value) remaining
on the dishes.
You can choose a value between 0
and 6.
Water Hardness
The factory setting “Hardness-Auto” allows
the deposit sensor to determine the
hardness and to control the softening
system automatically. This means that
changes to the settings are unnecessary
during start-up or in case of changes in
the water hardness.
Language
You can change the language selected
when the appliance was started for the first
time (see chapter “Before Starting The
Device For The First Time”).
If the option “Language” is chosen the
display shows several language
abbreviations. The abbreviation of the
currently selected language is flashing.
In order to choose a different language,
press – or +
3 until the desired
language appears.
Confirm the language selection by
pressing M/OK
2 .
All subsequent optical character
messages will be displayed in the selected
language.
To Next Page
Loading...
