What to do if my Kuppersbusch IWT 1459.1W does not work?
If your Kuppersbusch Washer/Dryer isn't working, try the following: First, depress the start button. Second, replace the fuse. Third, ensure the door is properly closed until you hear a click. If error code E40 is displayed, this is especially important. Fourth, make sure the plug is correctly inserted. Fifth, press the button. Finally, check the display for any selected delay.
Why Kuppersbusch Washer/Dryer machine does not fill?
If your Kuppersbusch Washer/Dryer isn't filling, it might be due to a few reasons. First, ensure the water tap is open. If error code E10 is displayed, this is likely the issue. Second, check the hose for any kinks and remove them. Third, clean the filter. Finally, make sure the door is properly closed, especially if error code E40 is displayed.
What to do if there is water on the floor from Kuppersbusch IWT 1459.1W?
If you find water on the floor near your Kuppersbusch Washer/Dryer, take these steps: First, measure detergent according to the manufacturer’s instructions. Second, ensure you are using a washing machine detergent that is suitable for your appliance. Third, check that the hose is firmly screwed on at both ends. Fourth, fully screw the filter into place.
Why Kuppersbusch Washer/Dryer machine does not empty and/or does not spin?
If your Kuppersbusch Washer/Dryer isn't emptying or spinning, consider these solutions: First, check the hose for any kinks and remove them. If error code E20 is displayed, this is a likely cause. Second, clean the filter or check the hose. Third, empty out the water. Finally, redistribute the laundry manually inside the drum.
How to fix Kuppersbusch IWT 1459.1W that vibrates or is noisy?
If your Kuppersbusch Washer/Dryer is vibrating or noisy, try the following: First, check that the machine has been unpacked as described in the Installation section. Second, carefully level the machine. Note that correct operation of the machine is not affected.
Why Kuppersbusch IWT 1459.1W spinning starts late or the machine does not spin?
If the spinning cycle in your Kuppersbusch Washer/Dryer starts late or the machine doesn't spin, it's likely due to unevenly distributed laundry. The machine detects this and attempts to redistribute it. If the laundry remains tangled after about 10 minutes, the machine won't spin. If your laundry is still wet at the end of the cycle, redistribute it manually and select the spin program again.
What to do if Kuppersbusch Washer/Dryer door will not open?
If the door of your Kuppersbusch Washer/Dryer won't open, try the following: First, wait until the end of the program before attempting to open the door. Second, ensure that the water has been emptied out before opening the door. Third, wait until the end of the heating phase.
Why Kuppersbusch IWT 1459.1W machine fills then empties immediately?
If your Kuppersbusch Washer/Dryer fills and then empties immediately, ensure the hose is placed at the correct height as described in the Installation section.
Why Kuppersbusch IWT 1459.1W will not dry or the laundry is not dry enough?
If your Kuppersbusch Washer/Dryer isn't drying or the laundry isn't dry enough, consider these steps: First, ensure the water tap is open, especially if error code E10 is displayed. Second, clean the filter. Third, select the appropriate drying time suitable for the required degree of drying, according to the type of fabric (cottons or synthetics). Fourth, reduce the load.
General safety rules for operating and maintaining the appliance.
Specific safety measures to protect children from hazards.
Detailed description of buttons, lights, and their functions on the control panel.
Step-by-step guide to loading laundry and selecting wash programmes.
Instructions for using the automatic, continuous wash and dry cycle.
Steps for cleaning the exterior, dispenser drawer, drain filter, and water inlet filter.
Guide to common issues, error codes, and their solutions.
Further troubleshooting for common problems like spinning, draining, and noise.
Safety rules for individuals performing the installation.
Step-by-step guide to unpack the appliance and remove transit safety devices.
Procedures for levelling the machine and connecting water hoses.
Guidelines for electrical connections, including permanent hookups.
General| Type | Washer/Dryer |
|---|---|
| Model | IWT 1459.1W |
| Capacity (Washing) | 9 kg |
| Capacity (Drying) | 6 kg |
| Energy Efficiency Class | A |
| Spin Speed | 1400 rpm |
| Dimensions (HxWxD) | 850 x 600 x 600 mm |
| Color | White |
To Next Page
