Installation & care
OR
Attaching the barrier
Detachable Headrests
Passenger Seat
Center Console
View from backseat
PARTS LIST & KEY
A elastic strap
with D-ring
B outer D-ring
C under seat hook
D top headrest strap
E top tension buckle
F under seat strap
G backseat divider
H backseat divider ring
I divider snaps
J backseat divider cord
K barrier extension
L metal bar slot
M extension zipper
N extension strap
O extension D-ring (small)
P extension buckle
Q under seat connector strap
R backseat divider strap
INSTALLED VIEW
Orient the barrier so the
Kurgo logo is facing the
back of the car. Remove the
driver’s seat headrest. Slide
the inner headrest column
through the large D-ring
attached to elastic strap
(A). Slide outer D-ring (B)
through outer headrest post.
Repeat on passenger side.
OPTION A - Clip hook (C) to
the underside of the front
seat base plate or springs.
OPTION B - Run strap (F)
around the outside footing
of each seat and secure
hook (C) by connecting
them to either end of
included connector strap (Q).
Pull top straps (D) tight on
both sides; pull both bottom
straps (F) tight.
5.09 For more information: 877.847.3868 :: www.kurgo.com :: info@kurgo.com
For an online video demonstration of how to
install the Backseat Barrier visit us at:
www.kurgo.com/support/instruction.html
To Next Page
Need help?
General
