EasyManua.ls Logo

Kurgo Back Seat Barrier User Manual

Kurgo Back Seat Barrier
2 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
OR
Attaching the barrier: Detachable Headrests
1. Orient the barrier so the
Kurgo logo is facing the
back of the car. Remove the
driver’s seat headrest. Slide
the inner headrest column
through the large D-ring
attached to strap (A). Slide
outer D-ring (B)
through
outer headrest post.
Repeat
on passenger side.
2. OPTION A - Clip hook (C)
to the underside of the front
seat base plate or springs.
OPTION B - Run strap (F)
around the outside footing
of each seat and secure
hook (C).
3. Pull top straps (D) tight
on both sides; pull both
bottom straps (F) tight.
Passenger Seat
Center Console
View from backseat
INSTALLED VIEW
Cup Holder
Pockets
Optional extra support for barrier extension:
Flip up orange velcro (G) and slide metal rod (H) through
slot (I) that runs across the top of the barrier between
the vertical bar pockets (J). Close and secure velcro (G).
To lower barrier extension:
1) Open velcro (G) on the left and right side, and remove
the metal bar found in each slot (J), also remove metal rod (H).
2) Roll mesh top from bar slot (I) down and tuck fabric
into large black pocket
Parts List & Key:
A inner D-ring
B outer D-ring
C under seat hook
D top headrest strap
E top tension buckle
F under seat strap
G steel support velcro closure
H horizontal steel support rod
I steel support rod pocket
J vertical steel support bar pocket
kurgo.com/product-instructions
2-15
Instructions and care

Other manuals for Kurgo Back Seat Barrier

Question and Answer IconNeed help?

Do you have a question about the Kurgo Back Seat Barrier and is the answer not in the manual?

Kurgo Back Seat Barrier Specifications

General IconGeneral
BrandKurgo
ModelBack Seat Barrier
CategoryPet Care Product
LanguageEnglish

Summary

Attaching the barrier: Detachable Headrests

Orient and Attach Headrest Straps

Orient barrier and slide inner/outer D-rings onto headrest posts for initial attachment.

Secure Barrier to Seat Base

Attach barrier to seat using under-seat hooks (Option A) or straps (Option B).

Tighten All Barrier Straps

Ensure barrier stability by firmly tightening all top and bottom securing straps.

TRAINING

Dog Familiarization with Car

Acclimate your dog to car rides, focusing on back seats before long trips.

Basic Obedience for Car Rides

Reinforce basic obedience commands like sit, stay, and come for smoother excursions.

Fixed Headrests Installation

Prepare Top Headrest Strap

Release the top headrest strap (D) from its buckle (E) for installation.

Wrap and Secure Headrest Strap

Wrap strap (D) around headrest, through D-ring (A), and back through buckle (E).

Cleaning Instructions

Hand Wash Procedure

Brush off dirt, spot clean with mild soap and water, rinse, and hang to air dry.

Related product manuals