Kurz B Series Installation

Kurz Instruments Inc. December 13, 2007
360210-AH Rev.A 504/534FTB Installation AH - 16
Optional Clip-on Ferrite for Signal Wires
If the I/O connections, 24 VDC, Modbus, analog outputs, or analog inputs (4-20 mA) are
not connected by a shielded connection, conduit or multi-conductor braded shield cable,
then these wires must be clipped in a ferrite to meet the EMC specifications. Figure AH-
9 shows and example of this type of wiring.
Figure AH-9 Clip-on Ferrite for I/O wires to be CE compliant without proper cable or
conduit shielding.
The Ferrite can be purchased from Kurz as part number 600029- or from the following
manufactures:
Steward 28A2024.0A2
Fair-rite: 0443164151:
Stock available from Kurz or Digi-Key Corporation (www.digikey.com
)
Clip-on
Ferrite

Kurz B Series Specifications

General

Brand	Kurz
Model	B Series
Category	Measuring Instruments
Language	English