5.1.5 - Channel
Board
To
remove the Channel board, it will be necessary to remove
the
following cables: 1 from the Audio board to the Channel board, 1
from the power connector to the
Chdnnel board. 1 coming from the
Slider board to the Channel board, 1 coming from the
CPU
to.
the
Channel board and 1 coming from the
CGP
to the Channel' board. It
is
not always necessary to remove the shield. However, if you are
replacing the Channel board,
be
sure that the shield
is
put
on
the
replacement. Once the
cables have
been
disconnected, remove the
13
phillips head screws holding the Channel board to the chassis. It is
necessary to have a very short screwdriver to remove the 2 screws
located at the inner edge of the board.
5.1.6 -
Audio
Board
To
remove the Audio board, simply disconnect the ribbon cable
from the Audio board to the Channel board. Next, remove all
hardware securing it
to
the rear panel.
Kurzwell250 Service Manual, Chapter 5
5-4
To Next Page
Loading...
