5.2 - FRONT PANEL ASSEMBLY
5.2.1 -
Accessing
the
Front
Panel'
Assembly
With this procedure you can reach and remove the three boards
mounted on the Front Panel assembly. You
can also remove all but
two of the wooden keys with the Front Panel up.
'Fo'r
most repairs, .
you will not have to remove the entire Front Panel assembly from
the instrument.
There are three steps for opening up the Front Panel assembly:
1. Loosen the two captive screws
on
the Front Panel assembly.
(One screw at
each·
end
of the Front Panel assembly.)
2. Lift the Front Panel assembly. from its bottom edge (edge
that meets keyboard). Carefully
lift the assembly up and
towards you about
an
inch. At this point the assembly could
rest on the sharp and flat keys.
3. The assembly is now free and can be pivoted
up
and back so
that the faceplate rests up against the
top enclosure (see
illustration below).
With the Front Panel assembly
in
this position, you can reach
the three boards.
Figure
5.1
Rear
of
Panel Will Drop
Q Pull Forward to End
of
Travel
Kurzwell
250
Service Manual, Chapter 5
5-5
Lift Up to Locked-in Position
To Next Page
Loading...
