5.6.7 - Channel
Board
To
remove the Channel board, it will be necessary to remove
the Power Supply enclosure and the following cables: 1 from the
Audio board to the Channel board, 1
Ifrom the ppwer supply to the
Channel board, 1 coming from the Control Panel board to the Channel
board, 1 coming from the
CPU
to the Channel Board and 1 coming
from the CGP to the Channel board.
It is not always necessary
to
-remove
the shield. However, if you are replacing the Channel board,
be
sure that the shield is put
on
the replacement. Once the cables
have been disconnected, remove the 8 remaining phillips head
screws holding the Channel to the inner chassis shelf.
5.6.8 -
Audio
Board
To
remove the Audio board, simply disconnect the ribbon cable
from the Audio board to the Channel board. Next, remove all
hardware securing it
to
the rear panel.
Kurzwell
250
Service Manual, Chapter 5
5
-1
6
(
To Next Page
Loading...
