DSP Functions
Pitch / Amplitude / Panner
14-33
independently for each wire, and keeps the two signals separate at its output, giving you
added flexibility for mixing and panning. Like the AMP function, UPPER AND LOWER AMP
always appears as the last block in an algorithm. Since it’s a two-stage function, it has two
control input pages. F3 selects the control input page for the lower wire, and F4 the control
input page for the upper wire.
EditProg:F3|AMP(AMP|U/L)|||<>Layer:1/1||
Adjust:0dB||||||||||Src1||:OFF||||||||||
||||||||||||||||||||Depth|:0dB||||||||||
||||||||||||||||||||Src2||:OFF||||||||||
KeyTrk:|0.00dB/key||DptCtl:OFF||||||||||
VelTrk:0dB||||||||||MinDpt:0dB||||||||||
Pad|||:0dB||||||||||MaxDpt:0dB||||||||||
<more||F1|||||F2|||||F3|AMP|F4|AMP|more>
PARAMETER RANGE OF VALUES
ADJUST -96 to 48 dB
KEY TRACKING ± 2.00 dB per key
VELOCITY TRACKING ± 96 dB
PAD 0, 6, 12, 18 dB
SOURCE 1 Control Source list
SOURCE 1 DEPTH ± 96 dB
SOURCE 2 Control Source list
SOURCE 2 DEPTH CONTROL Control Source list
MINIMUM DEPTH, SOURCE 2 ± 96 dB
MAXIMUM DEPTH, SOURCE 2 ± 96 dB
Balance and Amp (BAL AMP)
This function has a two-wire input and a two-wire output. The parameters on its control input
page affect the amount of gain applied to each wire between input and output. A value of 0%
applies equal gain to both the upper and lower wires; at a value of 100% only the upper wire’s
sound will be audible, at -100%, only the lower wire’s sound will be audible. This works like
the balance control on any stereo system; as the gain increases for one wire, it decreases for the
other. It’s also similar to the PANNER and XFADE functions. The F3 soft button selects the
control input page for the balance stage of this function.
EditProg:F3|POS(BAL/AMP)|||<>Layer:1/1||
Adjust:0dB||||||||||Src1||:OFF||||||||||
||||||||||||||||||||Depth|:0%|||||||||||
||||||||||||||||||||Src2||:OFF||||||||||
KeyTrk:|0.0%/key||||DptCtl:OFF||||||||||
VelTrk:0%|||||||||||MinDpt:0%|||||||||||
Pad|||:0%|||||||||||MaxDpt:0%|||||||||||
<more||F1|||||F2|||||F3|POS|F4|AMP|more>
PARAMETER RANGE OF VALUES
ADJUST ± 100%
KEY TRACKING ± 16.00% per key
VELOCITY TRACKING ± 200%
PAD 0, 6, 12, 18 dB
SOURCE 1 Control Source list
SOURCE 1 DEPTH ± 200%
To Next Page
Loading...
