Kurzweil K2600 - MUSICIANS GUIDE REV A PART NUMBER 910330 CHAP 16 User Manual

16-30
DSP Functions
The DSP Functions
Bass Tone Control (PARA BASS)
This is a two-stage function, with control-input pages for frequency and amplitude. These pages
are the same as those for frequency and amplitude in PARA EQ. On the frequency control-input
page, youÕll set the cutoff frequency. For notes above this frequency, the amplitude setting has a
diminished effect. On the amplitude control-input page, youÕll set the amount of cut or boost
thatÕs applied to notes below the cutoff frequency. ThereÕs a gradual increase in the bass
response for each successively lower note. The location of the cutoff frequency will change
somewhat as you change the amplitude settings, although the value for the Adjust parameter on
the frequency control-input page will not reßect the change.
0
2
4
6
8
10
12
14
16
10 100 1000 10000 100000
Frequency in Hertz
Amplitude in dB
Gain = 12 dB;
cutoff frequency
from C 2 to C 4
C 2
C 4
-20
-15
-10
-5
0
5
10
15
20
10 100 1000 10000 100000
Frequency in Hertz
Amplitude in dB
Cutoff frequency = C 3;
gain from -18 to 18 dB
18
6
-6
-18

Kurzweil K2600 - MUSICIANS GUIDE REV A PART NUMBER 910330 CHAP 16 Specifications

General

Mixer Type	Digital
Number of Output Channels	8
Effects Processing	Yes
MIDI Control	Yes
Sampling Rate	48kHz
EQ Bands per Channel	4