16-46
DSP Functions
The DSP Functions
The page below shows the DIST function in the F1 block, but it can appear in other blocks as
well.
EditProg:F1|DRV(DIST)||||||<>Layer:1/1||
Adjust:0dB||||||||||Src1||:OFF||||||||||
||||||||||||||||||||Depth|:0dB||||||||||
KStart:C|-1|unipola|Src2||:OFF||||||||||
KeyTrk:|0.00dB/key||DptCtl:OFF||||||||||
VelTrk:0dB||||||||||MinDpt:0dB||||||||||
Pad|||:0dB||||||||||MaxDpt:0dB||||||||||
<more||F1|DRV|F2|||||F3|||||F4|AMP|more>
SHAPER
The effect of SHAPER can be very unpredictable, and the mechanics of its operation lend
themselves toward explanations that are more numerical than verbal. The best way for you to
get a feel for the SHAPER is to start with single-cycle waveform keymaps and experiment with
different values for the parameters on its control-input page (labeled AMT, for Amount), and
listen to the results. SHAPER tends to work best with the single-cycle waveform sounds
(keymaps with IDs 112Ñ166), and is usually less effective with acoustic instrumental sounds.
SHAPER often produces numerous peaks throughout the frequency range, even at frequencies
that didnÕt have much amplitude to begin with. These peaks can sound like resonant Þlters, and
can even sound voice-like.
The two series of graphs that follow show the effect of SHAPER on two typical single-cycle
waveforms. The Þrst set of six graphs just below shows the evolution of a sine wave input as the
value of the Amount parameter is increased. The following set of six graphs shows the effect
when the Adjust parameter is increased. Each graph plots a 500-millisecond segment of
Parameter Range of Values
Adjust –96 to 48 dB
Keytrack Start C -1 to C 9 unipolar, C -1 to C 9 bipolar
Key Tracking ± 2.00 dB per key
Velocity Tracking ± 96 dB
PAD 0, 6, 12, 18 dB
Source 1 Control Source list
Source 1 Depth ± 96 dB
Source 2 Control Source list
Source 2 Depth Control Control Source list
Minimum Depth, Source 2 ± 96 dB
Maximum Depth, Source 2 ± 96 dB
To Next Page
Loading...