10-120
KDFX Reference
KDFX Algorithm Specifications
903 Resonant Filter
904 Dual Res Filter
Stereo and dual mono 2 pole resonant filters
PAUs: 1 for Resonant Filter
1 for Dual Res Filter
The resonant Þlter is available as a stereo (linked parameters for left and right) or dual mono (independent
controls for left and right). The Þlter type is selectable and may be one of low pass (i), high pass (ii), band
pass (iii), or notch (iv) (see Þgure below).
Figure 10-55 Resonant Filters: (i) lowpass; (ii) highpass; (iii) bandpass; (iv) notch
You can adjust he resonant frequency of the filter and the filter resonance level.
Parameters for Resonant Filter
Page 1
Wet/Dry 0 to 100%wet Out Gain Off, -79.0 to 24.0 dB
FilterType Lowpass
Frequency 58 to 8372 Hz
Resonance 0 to 50 dB
(i) (ii)
(iii) (iv)
To Next Page
Loading...