KDFX Reference
KDFX Algorithm Specifications
10-121
Parameters for Dual Res Filter
Page 1
Page 2
Wet/Dry The amount of Þltered (wet) signal relative to unaffected (dry) signal.
Out Gain The overall gain or amplitude at the output of the Þlter.
FilterType The type of resonant Þlter to be used. May be one of ÒLowpassÓ, ÒHighpassÓ, ÒBandpassÓ,
or ÒNotchÓ.
Frequency The frequency of the resonant Þlter peak (or notch) in Hz. The frequencies correspond to
semitone increments.
Resonance The resonance level of the resonant Þlter. Resonance sets the level of the resonant peak (or
the amount of cut in the case of the notch Þlter).
L Wet/Dry 0 to 100%wet R Wet/Dry 0 to 100%wet
L Output Off, -79.0 to 24.0 dB R Output Off, -79.0 to 24.0 dB
L FiltType Lowpass R FiltType Highpass
L Freq 58 to 8372 Hz R Freq 58 to 8372 Hz
LResonance 0 to 50 dB RResonance 0 to 50 dB
To Next Page
Loading...