10-164
KDFX Reference
KDFX Algorithm Specifications
Page 2
Page 3
In/Out When set to ÒInÓ the effect is active; when set to ÒOutÓ the effect is bypassed.
Out Gain The overall gain or amplitude at the output of the effect.
CrossOver1 Adjusts one of the -6dB crossover points at which the input signal will be divided into the
high, mid and low bands.
CrossOver2 Adjusts the other -6dB crossover points at which the input signal will be divided into the
high, mid and low bands.
Enable Low, Mid, and High. Turns processing for each band on or off. Turning each of the 3 bands
off results in a dry output signal.
Drive Low. Mid, and High. Adjusts the input into each transfer. Increasing the drive will
increase the effects.
Xfer Low, Mid, and High; Xfer1 and Xfer2 for Mid and High. Adjusts the intensity of the
transfer curves.
Delay Low, Mid, and High. Adjusts the number of samples the each signal is delayed.
Mix Low, Mid, and High. Adjusts the output gain of each band.
Lo Enable On or Off Mid Enable On or Off
Lo Drive Off, -79.0 to 24.0 dB Mid Drive Off, -79.0 to 24.0 dB
Lo Xfer -100 to 100% Mid Xfer1 -100 to 100%
Mid Xfer2 -100 to 100%
Lo Delay 0 to 1000 samp Mid Delay 0 to 500 samp
Lo Mix Off, -79.0 to 24.0 dB Mid Mix Off, -79.0 to 24.0 dB
Hi Enable On or Off
Hi Drive Off, -79.0 to 24.0 dB
Hi Xfer1 -100 to 100%
Hi Xfer2 -100 to 100%
Hi Delay 0 to 500 samp
Hi Mix Off, -79.0 to 24.0 dB
To Next Page
Loading...