KDFX Reference
KDFX Algorithm Speciļ¬cations
10-171
-3dB. Values above -3dB will cause somewhat of a bump in level as an image passes
through the center. Values below -3dB will cause a dip in level at the center.
LFO Shape The waveform type for the LFO. Choices are Sine, Saw+, Saw-, Pulse, Tri, and Expon.
PulseWidth When the LFO Shape is set to Pulse, this parameter sets the pulse width as a percentage of
the waveform period. The pulse is a square wave when the width is set to 50%. This
parameter is active only when the Pulse waveform is selected.
To Next Page
Loading...