Kurzweil K2600 - MUSICIANS GUIDE REV A PART NUMBER 910331 CHAP 10 - Page 55

KDFX Reference
KDFX Algorithm Specifications
10-55
be added to the input of the ßanger signal (Flanger 2 only). White noise has a lot of high frequency content
and may sound too bright. The noise may be tamed with a Þrst order lowpass Þlter.
Parameters for Flanger 1
Page 1
Page 2
Page 3
Parameters for Flanger 2
Page 1
Page 2
Wet/Dry -100 to 100% wet Out Gain Off, -79.0 to 24.0 dB
Fdbk Level -100 to 100% LFO Tempo System, 1 to 255 BPM
Xcouple 0 to 100% LFO Period 1/24 to 32 bts
HF Damping 16 to 25088 Hz
StatDlyLvl -100 to 100% L/R Phase 0.0 to 360.0 deg
LFO1 Level -100 to 100% LFO1 Phase 0.0 to 360.0 deg
LFO2 Level -100 to 100% LFO2 Phase 0.0 to 360.0 deg
StatDlyCrs 0.0 to 228.0 ms
StatDlyFin -127 to 127 samp
Xcurs1 Crs 0.0 to 228.0 ms Dly1 Crs 0.0 to 228.0 ms
Xcurs1 Fin -127 to 127 samp Dly1 Fin -127 to 127 samp
Xcurs2 Crs 0.0 to 228.0 ms Dly2 Crs 0.0 to 228.0 ms
Xcurs2 Fin -127 to 127 samp Dly2 Fin -127 to 127 samp
Wet/Dry -100 to 100%wet Out Gain Off, -79.0 to 24.0 dB
LFO Fdbk -100 to 100% Stat Fdbk -100 to 100%
Xcouple 0 to 100% LFO Tempo System, 1 to 255 BPM
HF Damping 16 Hz to 25088 Hz LFO Period 1/24 to 32 bts
Noise Gain Off, -79.0 to -30.0 dB Noise LP 16 to 25088 Hz
StatDlyLvl -100 to 100 % L/R Phase 0.0 to 360.0 deg
LFO1 Level -100 to 100 % LFO1 Phase 0.0 to 360.0 deg
LFO2 Level -100 to 100 % LFO2 Phase 0.0 to 360.0 deg
LFO3 Level -100 to 100 % LFO3 Phase 0.0 to 360.0 deg
LFO4 Level -100 to 100 % LFO4 Phase 0.0 to 360.0 deg