Maintenance and Troubleshooting
Troubleshooting
8-7
Programs, Setups, Songs, or Other Objects Are Missing
Battery has run down or has been disconnected. If the battery has failed, the message ÒBattery
voltage is low - X.X voltsÓ (where X.X is less than 3.0) will appear in the display on powerup. All
user data will be permanently lost if this occurs. See
Battery Replacement
on page 8-2.
Cannot Mount or Read Disk
1. Disk is not MS-DOS (or Akai, Ensoniq, or Roland) format.
2. Disk is damaged.
Cannot Write to Floppy Disk
1. Disk is not MS-DOS formatted.
2. Disk is write protected.
3. Sample is copy protected.
4. Disk is damaged.
Cannot Format Disk
1. Disk is damaged.
2. Disk is write protected.
3. You have instructed the K2600 to format a double-density (720K) disk as a high-density
(1.4M) disk. Note: Punching a hole in a double-density disk case to try to make the K2600
read it as a high-density disk is not a good idea.
To Next Page
Loading...
Need help?
General
