Setup Mode
The Control Knob
7-7
The Control Knob
The control knob gives you real-time control of five different parameters—the currently
selected parameter is indicated by the column of LEDs. By default these five parameters are:
• 1 Timbre
• 2 Mod
• 3 Envelope
• 4 Effect
• 5 Reverb
You can change what these five parameters are in Edit Setup Mode (see Edit Setup Mode on
page 8-1).
Pressing the Control Select button (located beneath the column of LEDs) changes the
currently selected parameter that is affected by the control knob. Note that when you make
a change to the current Setup using the Control Knob, the Save button LED will light up
indicating that a change has been made to the Setup. For more information on the Save
button and its LED states, see the section Saving in Setup Mode on page 7-11 below.
Each Zone of the Setup may have its own unique Control Knob parameters—you can
change what these five parameters are in Edit Setup Mode (see Edit Setup Mode on page 8-1).
Note that when you make a change to the current Setup by turning the Control Knob, the
Save button LED will light up indicating that a change has been made to the Setup. For
more information on the Save button and its LED states, see Saving in Setup Mode on page 7-11.
To Next Page
Loading...
