Kushlan 450DD - Page 7

Gearbox and Motor Assembly Parts List
Assembly Instruction
7
Step 1
Install Wheels on Lower Frame Unit
Step 2
Put on Washer and Snap on R-clip.
Step 3
Insert Draw Bar into Main Frame.
Step 4
Put on Swivel Bracket to Main Frame.
Step 5
Put in Bolt to Hold Main Frame to Draw
Bar.
Step 6
Take o the Four Outside Nuts and
Spring Washer.
Step 7
Check Inside Nut, so They are Tight.
Step 8
Connect Gear Motor Mounng Base to
Swivel Bracket Using the Pivot Pin.
Step 9
Install Gear Motor with the Nuts and Washers. They were removed before
Step 10
Install Front Dump Handle.
Step 11
Install the Back Dump Handles if Desire
For Your Operaon.