TECHNICAL
SPECIFICATIONS
Power Output
Preamplifier gain measured at 1.0KHz. Tone
controls maximum.
Signal-to-noise ratio.
Minimum input voltage required for rated output.
Tone controls adjusted for
12
o'clock position.
Bright
switch
in .
Drive
minimum
.
Volume
adjusted maximum.
Minimum input voltage required for rated output.
Tone
controls
adjusted
for
flat
response
at
1.0KHz. Volume adjusted maximum.
Power
output
measured into
two
3.0 ohm loads
at 1.0KHz. All tone controls maximum with
bright switch
in
.
Frequency response measured
with
tone con-
trols adjusted for flat response.
276
Watts
RMS@
1.0% THO
Channel I 30dB
Channel
II
39dB
Channel I Gain min. -77dB
Gain max. -58dB
Channel
II
Gain min. -81dB
Gain max. -50dB
Channel I 150mv RMS
Channel
II
22mv RMS
± 4.0dB 90Hz - 13KHz
To Next Page
Loading...
