Kustom KMA65 User Manual

1.) Mic Input - this is a 3 cond. XLR input jack for plugging in Lo-Z microphone or keyboard inputs. It has +15v Phantom
Power for condenser microphones.
2.) Line
Input #2 - this 1/4 2 conductor jack that allows you to plug in a Hi-z mic or keyboard or any line level source. It will
also accept guitar level signals as well.
3.) Line Input #3 - this is a 1/4 2 conductor input jack that will also allow you to plug in a Hi-z mic or keyboard or any line level
source. It will also accept guitar level signals as well.
4.) Volume 1 - this is the level control for Input #1.
Slowly increase the control to increase the volume. If you are using a keyboard
with a preamp, set its level for a mid position before increasing this control, otherwise distortion may occur. Both inputs follow the same
tone circuit as the other input.
5.) Effects - this control determines how much signal from Input #1 goes to the effects buss. Clockwise sends more signal
to the buss.
6.) Volume 2 - this is the level control for Input #2. As above on Volume #1, the same applies.
7.) Effects On/Off - this switch determines whether the signal from Input #2 goes to the effects buss. The overall level on
the Effects Level control determines the effects level on that input.
8.) Volume 3 - this is the level control for Input #3. As above on Volume #1, the same applies.
9.) Effects On/Off - this switch determines whether the signal from Input #3 goes to the effects buss. The overall level on
the Effects Level control determines the effects level on that input.
10.) Low - this control is the bass control for the amplifier. It is active and is set to boost or cut frequencies at 100Hz. Turning
it fully clockwise, the signal is boosted +12db. Turning it counterclockwise, the low will be rolled off -12db.
11.) Lo-Mid - this control is the lower midrange control for the amplifier. It is active and set to boost or cut frequencies at
500Hz. Turning it fully clockwise, the signal is boosted +12db. Turning it counterclockwise, the low will be rolled off -12db.
12.) Hi-Mid - this control is the upper midrange control for the amplifier. It is active and set to boost or cut frequencies at
1.5KHz. Turning it fully clockwise, the signal is boosted +12db. Turning it counterclockwise, the low will be rolled off -12db.
13.) High - this control is the high frequency control for the amplifier. It is active and set to boost or cut frequencies at 5KHz.
Turning it fully clockwise, the signal is boosted +12db. Turning it counterclockwise, the low will be rolled off -12db.
14.) Master Volume - this is the Master Volume control for the entire amplifier.
15.) Effects On/Off - this switch engages the digital effects section.
16.) Effects Level - this control adds the digital effects section and mixes it into the main signal buss. Several different
effects are available.
17.) Program Select - this switch will select any of eight different effects. 4- Reverbs, 2- Echos, 1-Chorus and 1-Chorus/Reverb.
18.) Jewel Light - this jewel light lets you know that the amplifier is on.
19.) Power - this switch turns on and off the AC power to the amp.
Back Panel - (not pictured)
Speaker Out - this is a 2 conductor 1/4 speaker output jack. This will disconnect the internal speaker and allow an external
speaker cabinet to be employed. Rating is 8 ohms.
Line Output - this is a 2 conductor 1/4 line output jack. This will allow an external amplifier or mixing board to be supplied with
the signal from this amp.
Effects Loop I/O - these are 2-2 conductor 1/4 jacks. This will allow an external effects device or equalizer to be patched back in before
the power amp section in this amp. One is send and the
other is return.
Footswitch Jack - this is a 3 conductor 1/4 jack. This is for hooking up a footswitch to turn on/off the effects section.
541 2 3
15 176 8
12
13 16 18 197
9
10 11 14
1. BRIGHT ROOM
2. MELLOW ROOM
3. BRIGHT HALL
4. MELLOW HALL
5. CHORUS
6. CHORUS/REVERB
7. SLAPBACK
8. ECHO
PROGRAM
LEVEL
5
6
7
8
2
3
4
1
POWER
HI-MID TREBLEEFFECTSVOLUME 1
65 WATT MOSFET KEYBOARD/MIXER AMPLIFIER
INPUT 3
LINE/HI-Z
INPUT 2
LINE/HI-Z
INPUT 1
MIC
KMA65
INPUT 1
VOLUME 2 LO-MIDBASS
ON
VOLUME 3
EFFECTSEFFECTS
VOLUME
DIGITAL EFFECTS EQUALIZERINPUT 2 INPUT 3 MASTER

Kustom KMA65 Specifications

General

Brand	Kustom
Model	KMA65
Category	Amplifier
Language	English